Just in time!

prowler13angler · Post by **prowler13angler** » Sat May 27, 2006 6:55 pm

Was just about to post this on the General forum.

How do you guys install the Extra scotty rod holders, when you have the Flush mounts already there? Theres really not any flat space in the back. What do you guys do?

Rev. Tom · Post by **Rev. Tom** » Sat May 27, 2006 6:58 pm

Could you mount it along the wall of your tankwell and use the hole on the side of the mount instead of the hole on top?

Todd · Post by **Todd** » Sat May 27, 2006 7:11 pm

Why are you putting a scotty there?

If you are trying to carry more rods you can put a pvc extension in the flush mount that can carry at least three, more if you want to get creative.

prowler13angler · Post by **prowler13angler** » Sat May 27, 2006 7:20 pm

Just if i got the scotty's it would look a little better than PVC, and would hold rods better.

Ive seen people have them.

Mako · Post by **Mako** » Sat May 27, 2006 9:08 pm

how about this?

Todd · Post by **Todd** » Sat May 27, 2006 9:49 pm

Mako wrote:how about this?

That is what I was talking about.

Sledford · Post by **Sledford** » Sun May 28, 2006 11:32 am

You could replace your flush mount rod holders with the round flat scotty mount base.